(list of all automatically detected machines) John Deere Large Ag Tractors John Deere Large Ag Tractors Use of the iGrade antenna generally improves performance when experiencing conditions described above, but does not guarantee sub-inch grading accuracy. The iGrade antenna is recommended for commercial and high-use operators of iGrade using StarFire 3000 Receivers. If a StarFire 3000 is used on the machine, a StarFire 3000 must be used on the implement. Use of the iGrade StarFire GNSS antenna in any other manner is neither permitted nor supported and can degrade desired performance of the paired receiver. The StarFire 3000 Receiver must remain mounted to the same implement as the iGrade antenna being utilized. The iGrade antenna is only compatible with StarFire 3000 Receivers and is only intended for use on the implement receiver utilizing iGrade or other earthmoving applications. Implement receivers in horizontal-accuracy-only applications.The iGrade antenna is only necessary for iGrade users demanding the highest possible vertical accuracy for their applications and should not be installed on the following: It is compatible with global positioning system (GPS) offering L1, L2, and L5 satellite signals and Russian satellite constellation (GLONASS) offering G1 and G2 satellite signals, as well as the StarFire network (L-band), making it an excellent enhancement to the StarFire 3000 Receiver. The iGrade antenna resists signal interference, allowing for the rejection of error that can typically be caused by multipath effects. Vertical accuracy can be impacted by signal interference that the StarFire 3000 Receiver is susceptible to, such as multipath. The iGrade StarFire GNSS antenna (iGrade antenna) facilitates enhanced performance of the implement’s StarFire 3000 Receiver when utilized for iGrade that requires maximum vertical precision. The vertical accuracy performance of the StarFire 6000 with internal antenna for iGrade applications is similar to that of the StarFire 3000 with external iGrade antenna. The StarFire 6000 Receiver is not currently compatible with external antennas. The John Deere Application Controller 1100 is required for iGrade activation. IGrade requires the receiver to have an RTK signal level. iGrade does not support WAAS, EGNOS, SF1, SF2, or SF3 signal levels. Compatible with integrated AutoTrac, AutoTrac Controller, and AutoTrac Universal.*When equipped with optional electronic SCVs.Any SCVs can be used and an option connector is not used.
#Igrade plus registration series#
Non-John Deere tractors, 60 Series and older tractors, 5XXX, 6X00, 6X10, 6X30, 7X00, 7X10, and Small- Frame 7X20/7X30 Tractors.Then it’s on to the next one.IGrade is approved for the following platforms:
After we are done with the pass we feathered out the sides manually and make one last pass through the middle to clean it up. Then iGrade takes over and automatically lowers the ditcher and raises it to make the desired slope and depth of the cut.
#Igrade plus registration pro#
Surface Water Pro shows us how much dirt we are expecting to move and a side profile view so we know how close we are to our desired cut. We then entered our min/max slope and our min/max cut by using the best fit option and then generated a ditch track.
After the initial setup, we were able to use Surface Water Pro by surveying our ditch track and recording the elevation every 5 feet. It amazed me how far the dirt was being thrown from the ditcher (in excess of 40 yards). With the recent dry weather we are making ditches to drain the wet holes that have been hard to get rid of the past couple of springs. I got the chance to ride with a customer who is running John Deere Surface Water Pro and iGrade with a Wolverine ditcher pulled by a JD 8430 tractor with SF3000 receivers and Sloan Implement RTK network.
0 kommentar(er)
